| |
 |
| PPPD Configuration |
- Ensure that your kernel is compiled with PPP support. This can
be done either as a module or as a compiled-in driver. If you
are not certain, cd to /usr/src/linux and do 'make menuconfig' and
go through the Networking sections to be sure that PPP support is
configured. If you choose to make this a module, do not forget
the 'make modules' and 'make modules_install' steps after the main
kernel image has been compiled. If you are not familiar with
kernel compilation, read the Kernel-HOWTO.
- You need to place two files in your /etc/ppp directory. This
must be done as root. First, you need to overwrite your /etc/ppp/options
file with this one. Then you need to add the scriptfile. The files
given here are generic; you should edit /etc/ppp/scriptfile to
add the username, password, and phone number you will be using and
the options file assumes that a symlink /dev/modem exists. If it
does not, cd to /dev and create it. COM1 in Windows is /dev/ttyS0 in
Linux, COM2 is /dev/ttyS1, etc. Type 'ln -s /dev/ttyS1 /dev/modem' to
create a symlink called /dev/modem that points to a modem on COM2.
- Be sure to do 'chmod 755 /etc/ppp/scriptfile'.
- Next, we need to configure DNS. This is done by editing /etc/resolv.conf
and adding these entries:
domain Lynchburg.net
nameserver 216.207.176.3
nameserver 216.207.176.9
Then edit /etc/host.conf to contain:
order hosts,bind
multi on
Notice that in the actual config files, these lines need to be all the way
to the left.
Tip: Running your own DNS server will give you even
better performance with lower latency and local caching. In
order to do this, read the DNS-HOWTO thoroughly.
- Your PPP daemon is now configured. To dial into the Internet,
as root run the command 'pppd'. To disconnect, run 'pppd' again
or simply do 'killall pppd'.
|
| | |
| |
Copyright 1999 Lynchburg.net. All rights Reserved
7109 Timberlake Rd. Suite 201 - Lynchburg, VA 24502
Phone: 434.239.4272 - Fax: 804.239.0744
Questions or Comments: webmaster@lynchburg.net
|
|